Messages

thanks for the feed back im unsure what kind of shifter it is but would rather make it colum change than move the floor shifter and as for putting the grey box back in I was told it wouldnt handle the 186 :-\

My fc has a 186 engine with what i am told is a three speed torrana gearbox and so has been converted to floor change with a toyota hilux seat to allow for the gear stick . I want to put the original seat back in and put her back to column change but the configuration of the column doesn't match that of the gearbox and so was wondering if anyone knew of an addapter part I could buy as they seem to be available for a column to floor conversion
cheers ???

thanks for that all good infomation

If thats what they are off when i got the seat the passenger side surround was chucked in I thought they must have been an after market thing . I'm recovering the seat and just thought the metal surrounds would look better if I could find a drivers side surround

sory i havent worded that very well i mean im after the moulded metal seat surround rather than the plastic ones

im looking for the metal set trim for the drivers side i already have the passenger side
cheers

im in new zealand thanx for the info fellas just tossing a few idears around

hi guys looking for a front bench seat anything cosnidered
cheers ;D

Hi guys Im looking for the oil seal that goes at the bottom of the steering colum to keep the oil in the steering gear box .I have searched for a supplier here in new zealand but according to Rear Spares they stopped making that part in 1989 . I was was wondering if anyone knew of any supplier in  Austrailia I could source the part from
Cheers  ;)

Looking for a 3speed fc gearbox its going behind a 186
Cheers  :)

HI guys im currently doing up my steering box for my fc holden. I brought a berrings and bush kit from rear spears  but it did not include the bush in the top plate witch holds the lash screw. Apparently this was originly sold as one complete pice and is no longer made . Have my fine friends across the ditch have any suggestions?.
Cheers Kiwi FC Bryce

Still no one out there who wants to sell a steerng wheel? :)

hi guys anyone got a gearlever for fc coloum change they are willing to sell?
Cheers Bryce ;D

Thanks very much for the help . Im new to this so I may have some stupid questions.
cheers

  how hard do you think it would be to make some?
Thanks for the help
Bryce ;)

The slector linkage comes out of the side of the gear box but the rods are shaped for the linkage to come out of the bottom of the box?

Hi guys when i got my FC it had been convreted to floor change with an 3spd EH box . I want to change it back to coloum change but the FC rods from the gearbox to the coloum linkage wont fit . Will the EH ones fit?
Cheers Bryce ???

Also looking for a gearlever for coloum change for a fc

Thanx very much ;D

hi clint if you could give me a phone number or sumthing so i could get a hold of you that would be great cheers