Sand blasting will pit the sheet metal best you use plastic grit blasting leaves no marks on metal.If your in melbourne theres a place in Campbellfield called Carstrip p/l hope this helps cheers Demon
- Welcome to FE-FC Holden Discussion Forum.
News:
Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Board / Re: Engineer's report
May 01, 2002, 01:39:48 AM
What if the car is all ready registered with a red motor cheers demon
#3
Modification Help / DIFF
April 26, 2002, 08:36:37 AM
Can you use the HR diff housing and bolt it to the fe ute springs using the hr 4 bolt plate or do i have use the u bolts Thanking you Demon
#4
Modification Help / Front end red motor
April 22, 2002, 09:24:53 AM
HR front end would anyone known how far back the engine mounts need too be welded and what height .Thanking you for your help. Demon
Pages1