News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - horrie58

#1
Parts Wanted / Wiper Motor Needed
January 15, 2008, 09:58:20 AM
The 1st real rain this year and my wiper motor has failed, basically worn out and I need a replacement. AC Delco single speed unit would be ideal, but a dual speed or modified unit or suggestions on a fix would be appreciated.
Greg, Cairns
#2
Parts Wanted / Interior door & Winder handles reqd
January 20, 2006, 10:19:58 AM
 I need a set (2) of interior handles..window winder & door release handle...for LHS !! Preferably in good condition...Mine have the inner splines flogged out after 45 years of use and I need some more.Will pay top dollar for good items.
#3
Parts Wanted / Passenger Door..Van/ute Fe/Fc
February 28, 2005, 09:51:50 AM
Help me I need a Lhs front doof for my 58 Van.Ideally in fairly good nik so I can get it painted with minimal prep.I am prepared to pay a good price for the right item.My problem is my van is a daily workhorse so I cant afford down time.
Glassware.trim etc would be a bonus but not a pre requisite.
Greg :)
#4
Parts Wanted / Re: Clutch return spring
December 18, 2003, 07:47:22 AM
Thanks for the replies
Bought a spring,albiet non genuine and the same only different to do the job .
#5
Parts Wanted / Clutch return spring
December 15, 2003, 03:57:21 AM
ever been driving along , peacefully changing into top when suddenly the large spring taking up the slack in the clutch pedal parts company with the place it has lived for 45 years and smacks you in the roger smalls.

My problem now is not the squeaky voice but i need another spring , of good quality,to avoid another occurrance.

I have a temporary fix in place but would like to maintain the originallity of my FC Van.

I reside in Cairns.Where old Holdens holiday.!
#6
General Technical / POPPING UNEVEN IDLE
September 24, 2002, 10:14:28 PM
My grey motor is bog stock and has developed  an uneven idle and run to 2500rpm.At idle the motor is fairly smooth as it should be however intermitantly it gives a little shake,like a hiccup every now and then,whether hot or cold.at the exhaust i can hear what sounds like a popping noise.It runs like this up to 2500rpm,on the road under load there is no roughness or power loss.Valve clearances ok.timming ok, :'( ;D