Messages

Have a carby in Casino if that helps at all.

Might have a carby here in Casino for you. I will have a look.

The next addition, Weber and Headers... ;D

Weld porn.... ;D

Awesome....that is all.

See different sized Hunny pots  ::) ;D

Pooh bear...it's all his fault I tell ya  :P

Thanks for the help Ken & haydn.

I am about to start rebuilding a HR front end for the Ratty Taxi, I have a set of HG,K,T stub axles and steering arms. I know they bolt on and lower car by about an inch. What problems could I encounter with this setup eg, alignment issues ect ? Any help appreciated

I think it all started when Winnie the pooh was working at Holden, he started to blow out so they had to make smaller honey pots.
This story may or may not have any factual truth.

Yeah Nick, you will...lol

We were another rescue mission for Pete, with Pete fixing the dodgy seatbelt mounts with some new plates and bolts. Had a great night at the pub to follow.

someone needs to proof read their ads.[ebay]251491733430[/ebay]

Dave & I are going over on the Wed night & coming back on the Tue night.

Thanks guys, means a lot to know the hard work paid off.

Dean.

I put the 2" blocks in the rear of the car today, looking better now.

I feel inferior with my 149...lol. On a serious note, can't wait to see it in Tassie.

The tyres are whitewall Graham, bought from John Cain. Cost a small fortune but worth every cent.

Dean.

Lovells super lows with a coil cut.....just for good measure. Will probably go with 2 inch blocks in the back.