Messages

Hello Ken
You must be on line now.
Interseted in seat . What condition?
Just down the road in Geelong.
Nick

Simon
I would'nt use lead filler.
Build up with Mig and grind down finish off with a belt sander 80/120 grit . Comes up a treat.
Nick

Picked up a tail gate skin at Bendigo swap.
Any advice,tricks or problems with fitting?
Nick

Finished the station wagon now going to do the rear glass on the ute.
How???
Do you fit the 3 sections and the trim all in one, or fit the trim last?
Have rare spare seal hope its a better fit than wagon.
Thanks for any help
Nick  

I'll give that a go.
Thanks
Nick

Thanks for the info.
Got the last one in ok.
The rubbers were'nt the greatest fit top rear corner on both sides
out  about half inch. Still if they keep the water out it will be great.
Nick

Just spent ages fitting new seals to rear windows. Tail gate was'nt too bad but sides very tricky.
Fitted from the inside and pulled string outward, very tight fit used feet.rubber mallet, is the right way to go about this????
Still have the other side to do and am worried might smash glass!
Any advice , tips, words of warning, greatly appreciated.
Nick

I have 2 speed wipers possible to fit intermittent unit from early commadore or any other suggestions.
Nick

Is it possible to turbo charge a grey motor? i recently came across a set up for an early ? red motor and very neat it was.
Any ideas, solutions any one done it?
Nick

Desperately seeking advice, magazine articles,bits regarding fast grey motors also information on fitting austin lancer???? gearbox with mga close ratio gears to grey? whereabouts of any high performance parts or anyone with any specialist knowledge. Any help greatly appreciated.

Any idea where to get hcp in Vic for grey head,cam etc done .Want more power. Any info appreciated.

any one know where to get wiper arms for fc ?

Is the EK/FB ute venetian the same as the FE/FC? Thanks.

CAN ANY ONE HELP.I WOULD LIKE TO BUY FRONT SEAT IN RED/BLACK FOR FC STATION SEDAN ALSO ANY BODY KNOW WHERE I CAN GET THE INNER FABRIC COVERED WINDSEAL? THAT GOES ROUND THE DOOR FRAMES IT SEEMS TO HAVE A LITTLE FLANGE THAT PUSHES INTO A GROOVE? REAR 2 PIECE TRIM PANELS MADE IN A THIN BOARD  ALSO WANTED SEAT FOR EK UTE.ANY INFO APPRECIATED

Anyone know where I can get old books, mags re tuning grey motors.Looking to get 130-150 BHP! Any help greatly appreciated.