Messages

PM sent Greg.

Thanks Mark

I’m chasing a rear quarter panel stainless moulding for my FC sedan,  after one with no dints, bends or holes drilled in it.



Im from Ballarat Vic but happy to travel if i can't get one local.

Cheers Mark

Thanks Dave,

Look forward to seeing the pics.

Cheers, Mark

G’day all, here is a list of some parts i’m chasing for my FC,

Drivers side rear ¼ panel stainless moulding
Lower grill bar, not the big one the bottom stainless one
Good hubcaps
Left rear door window divider
Drivers side lower plastic seat surround trim, cracks are ok just needs to be all there
Pair front door handles

I know some of these parts are reproduced now but I would like to get original parts in good condition if I can find them.
I’m located in Ballarat Vic but happy to travel or pay for postage!

Cheers Mark

It was too easy, got a harder challenge haha, a few years ago i bought an FE for parts, i remember removing them to try and free the locked on brakes!  :)

Brake drum retaining clips 8) where do i collect my prize?  ;D

PM sent  :)

PM sent about the strips 

Mark

PM sent..

Mark

Thanks Ken, some pics would be great, ill send you a pm.

Mark

Ok maybe i was a bit optimistic wanting some with no dints but does anyone have some stainless steel hubcaps?

Mark

Here is mine as it sits now, not quite completed but almost complete, only a few bits missing now.



Not its actual ride hight its just sitting on bricks with the wheels stuck under it  ;D lol

Mark

I did in the parts for sale section but here they are for you if you cant find them

FE/215 1062M
Trim 5 - 477
Paint 258 - 7467

Subframe 714540M

Engine L417711

Mark

haha yeah i should have said whats left of the FE im wrecking, i cut through the front pillars and it buckled in the middle, only had to cut the gearbox tunnel and it was in half.

Mark

Thought you guys would want to see a video of me starting the grey motor in the FE im wrecking, its been sitting idle for at least 25 years, all it needed was a coil and leads from my FC and some "start you bastard" down the carby..

[youtube=425,350]http://www.youtube.com/watch?v=9G1w3lyAOco[/youtube]

once it warmed up it ran great!

[youtube=425,350]http://www.youtube.com/watch?v=XJB23rMxfE0[/youtube]

sorry about the quality its off my phone
Cheers, Mark

Hi all, in after 2 or 3 stainless steel FE/FC hubcaps, with few or no dints.

Cheers, Mark

Thanks John, i thought that might have been the case, so now im looking for a usable rear wheel cylinder.

Mark

Im looking for a left hand rear wheel cylinder for my FC, one that doesnt leak >:( i know you can buy these new but it wont be on the road for a while so im looking for a decent second hand unit to put on it now so i can drive it round to keep everything working.

Thanks, Mark

Here are the details for you Ken,

FE/215 1062M
Trim 5 - 477
Paint 258 - 7467

subframe 714540M

engine L417711

and ashfe, you have mail

Mark

Sorry i forgot to say im in Ballarat Victoria, i have replyed to everyones pm's and dont worry Ken ill be getting the details for you... Thanks

Mark