I am installing a holden red motor with a 4 speed borg warner top loader into my FC ute. I have moved the mounts on my HR disc brake front end cross member back. Should I have to cut part of the floor tunnel to fit everything in?
- Welcome to FE-FC Holden Discussion Forum.
News:
Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Board / Installing 308 into FC.
January 31, 2010, 05:26:55 PM
Have removed my holden red from FC ute, still has HR disk brake underneath. Now wanting to install a 308 and turbo 400 which i have purchased. What is the best rack and pinnion for the job, and also the best gear box tunnel? regards, morry.
#3
Modification Help / Re: hood lining
February 19, 2007, 09:48:45 AM
thanks glen, i'm in vic
regards morry.
regards morry.
#5
Modification Help / hood lining
February 18, 2007, 08:16:39 AM
where can i locate a good fitting hood lining for a fc ute.(new) ;D
#6
Modification Help / accelerator cable
February 18, 2007, 01:34:10 AM
what accelerator cable do i use on an fc with a holden red 6 cyl with twin carbies.
#7
General Board / accelerator cable
February 18, 2007, 01:34:10 AM
This topic has been moved to [link=http://www.fefcholden.org.au/cgi-bin/yabb/YaBB.cgi?board=hotup;action=display;num=1171697413;start=0]Modification Help[/link] by stinky.
Pages1