News:

Are you a member of one of the FE-FC Holden Car Clubs of Australia ? If you are, get access to the Club-Member-only area of this discussion board. Send an IM to the board admin, including your real name and club to get access.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Willy

#1
General Technical / Re: Sourcing Whitewalls
September 21, 2005, 05:28:48 AM
You dont know what the prices are do you?

Im tossing up whether to buy 14" ones and have them put onto the tyres properly or whether I should just by the 13" again and throw them under the hubcaps...
#2
General Technical / Re: Sourcing Whitewalls
September 21, 2005, 05:27:02 AM
Thanks Greg, I must have been on the right track there, I called but no one picked up, I was going to call again tomorrow...

#3
General Technical / Sourcing Whitewalls
September 21, 2005, 05:13:11 AM
Hi Guys,

I drive a MX23 1974 Toyota Mark II Hardtop (sorry its not a holden haha)

My dad used to be affiliated with the NSW section of the club, I found some whitewalls down beside the house the other day for my Mark II... theyre 13" and they were made by Atlas, i decided to squeeze them around the hubcaps and then put the hubcaps on the rims, the results speak for themselves...



This is written on the whitewall...



Any help is greatly appreciated...

Keal