|
Title: HR Front end Post by: canary on August 20, 2009, 08:41:46 PM Want to known if i use FE bolts or HR ones to fit front end to sub frame also do I tighten to fe or hr spec
THANKS in advance Brian Title: Re: HR Front end Post by: mcl1959 on August 23, 2009, 04:48:05 PM You have to use sort of a half / half mixture unless you modify the front end to make it like an FC front end. This is my suggestion:
FC has a 3 layer rubber bush whereas HR only has 2. So you need to use the FC upper long spacers (correct ones for front and rear) and the FC upper rubber bush and middle bush and then the lower FC bush, short spacer and square washer is deleted. You should tighten the bolts as per HR spec. Ken Title: Re: Re: HR Front end Post by: mph on February 13, 2020, 10:42:11 PM You have to use sort of a half / half mixture unless you modify the front end to make it like an FC front end. This is my suggestion: Old thread but just what I'm looking for thanks FC has a 3 layer rubber bush whereas HR only has 2. So you need to use the FC upper long spacers (correct ones for front and rear) and the FC upper rubber bush and middle bush and then the lower FC bush, short spacer and square washer is deleted. You should tighten the bolts as per HR spec. Ken Sent from my SM-G970F using Tapatalk |