I have just wired a relay to my ignition wire to utilise 12 volts on my electronic dizzy.
I cannot switch the motor off using the key now.
I have been told that the wire from the alternator to gen warning lamp runs enough voltage to hold the relay open and causes this problem. The remedy is to fit a diode to the genwarning lamp wire.
Could someone please assist me with some more indepth instructions on how to perform this task>
Cheers
Dave
grab a diode, which only allows current flow in one direction.
solder it in place in the desired position, put heat shrink over the soldered joints.
test out its polarity using a test light or multi meter.
easy?
Ed