Print Page - Air-Con questions

Title: Air-Con questions
Post by: sgo on July 06, 2006, 09:42:41 AM

Do we have any Air-con technitions that can answer a few questions here?
I'm trying to install an old under-dash unit to a new compressor etc.

Title: Re: Air-Con questions
Post by: fccool59 on July 06, 2006, 09:50:22 AM

heateracman?, I think they scared him off but.

Title: Re: Air-Con questions
Post by: FCwagon on July 07, 2006, 02:09:22 AM

An older evaporator unit can be used with new type compressor. Just need to match the receiver/dryer and TX valve to meet the compressor specs.
Leigh

Title: Re: Air-Con questions
Post by: sgo on July 07, 2006, 02:53:35 AM

Thanks for the reply.
But that leads into another question.
The TX valve is atached to the evaporator, so how do I know if it matches the compressor, and is it just a matter of changing it if need be?
The other queries I have are:
Where do I plumb in a valve to fill the system?
I have one hose-end fitting that attaches to the compressor, that has a valve fitted, would that be all that is needed?
Also the wiring loom I'm using is VP Commodore and has a connection for a pressure switch on one A/C hose. Do I need to run a pressure switch, if so where to fit it, or can it just be by-passed it altogether? ???

Title: Re: Air-Con questions
Post by: ACE on July 07, 2006, 04:04:46 AM

Hi sgo,
Dr Terry is the man to talk to about Air Conditioning ;)
He has a business that specializes in car air conditioning.
Regards ACE 8)

Title: Re: Air-Con questions
Post by: oldgmh on July 07, 2006, 08:17:14 PM

heateraceman's phone number is 07-36232133. He has lots of bits'n'pieces.

regards
earlee ;D ;D

Title: Re: Air-Con questions
Post by: sgo on July 11, 2006, 09:18:21 AM

Story continues at:
http://www.fastlane.com.au/forums/topic.asp?TOPIC_ID=7671
;)

FE-FC Holden Discussion Forum

Technical Board => Modification Help => Topic started by: sgo on July 06, 2006, 09:42:41 AM