|
Title: boot spring unsprung! Post by: Sheriff on July 02, 2006, 02:38:30 AM For some unknown reason, my driver's side boot spring came adrift when I closed the boot this morning. I see in the manual that a special tool is needed to refit it. Has anyone any experience with this? I imagine such a tool is unobtainable and the only option would be to get one made up. Maybe someone has an alternative idea? Any help would be appreciated. Thanks, Mike.
Title: Re: boot spring unsprung! Post by: mcl1959 on July 02, 2006, 02:54:56 AM Check the shaft that the spring mounts on, usually the reason the spring comes off is because the shaft gets worn and then either bends or a piece breaks off. I have a tool which you could borrow but you may be able to find one a little closer.
Ken Title: Re: boot spring unsprung! Post by: Sheriff on July 02, 2006, 03:37:46 AM Thanks Ken. Shaft does not appear broken. It resembles a large split pin with the ends slightly splayed. Appears solid though. I'll see how I go on the forum for a closer tool for the time being. Thanks for the offer. Mike.
Title: Re: boot spring unsprung! Post by: weddo on July 03, 2006, 11:56:06 PM Mike,
I had a similar problem with both springs, one side came off - the other side the pin had broken. I removed the springs, pins and brackets and replaced them with gas strutts and haven't had a problem since Weddo Title: Re: boot spring unsprung! Post by: cruiser056 on July 04, 2006, 12:11:14 AM Mike,
I had a tool made up to the picture in the work shop manual, you can borrow also. Where are you located? Michael Title: Re: boot spring unsprung! Post by: RET on July 04, 2006, 01:10:32 AM Even with the tool it's a mongrel job. There's a lot to be said for acquiring or fabbing a set of adjustable springs.
Basically it's just a biggish bolt with a slot cut into the threaded end that you replace the old pin with. A decent size ratchet handle on the bolt-head lets you tighten the spring from its inner lug, rather than from the outer edge using the tool. A lock-nut on the inner face (put that on first, of course :-/) and you're away. Another nut finger-tight after the spring is fitted can help to keep the slotted end from flaring when you start loading up the spring. Hope that helps, RET Title: Re: boot spring unsprung! Post by: Sheriff on July 04, 2006, 04:49:32 AM Thanks for the clues fellows. Michael, I am at Highfields just outside Toowoomba. Will send you a pm. Mike.
Title: Re: boot spring unsprung! Post by: Rusty_T on July 04, 2006, 09:06:41 AM >:(
Mike ,I had a similar problem with my boot not staying open and upon inspection found the left spring was in back to front and the mechanism had some how flipped through, causing it to work against the other spring and drag the boot shut.It took a bit of time to work it out hense the "NASCO Boot stick".Anyway what I did was make a special tool for the springs using the diagram from the Workshop Manual. With a screw driver and a cover (rag) over the spring (to keep it from doing me any damage)and to keep it within the boot worked it and the mechanism off,turned it the right way round and using the "Special Tool" fixed it back into place. I also found it easier to do with the boot closed partially as there is less tension on the spring and a piece of cloth over the boot lock to prevent being locked in.It took me about 20 mins to do but the end result is the boot stays up unassisted. Cheers Rusty (And good luck) |