I have just purchased a high quality harmonic balancer puller and I was told to "put something on the end of the crank" to prevent driving the puller bolt/pin into the crank. Has anyone heard of this being a problem? If so, what would be a suitable item/technique to prevent this happening?
Thanks
Dave
never heard of that Dave...
spose you could put a small round bit of sheet there.. maybe centre punch it to keep it in place.
Cheers
Ed
Dave
I have. I borrowed one from an old retired mechanic. He had a round disk ( around 4mm thick) as part of the set, said it stopped the point digging into the crank and spreading it.
Andrew
Dont know how the gray ones are held on but i usually put the bolt back in without the washer!!! 8)