Print Page - Red motor diff to grey motor diff centre

Title: Red motor diff to grey motor diff centre
Post by: TAYZ on March 15, 2006, 10:44:04 AM

I have just installed a worked grey into my ol FC thanks to FEHOTROD. Any how i have purchased a 3.55 diff centre from a HQ Holden. I have pulled the old one out and are about to put the new one in. The rear unis are different. What do i have to do to match up the grey tailshaft with the red banjo diff? I have purchased 2 U bolts and a red banjo uni joint, will these fit up OK?? cheers all (my mechanical knowledge is very minimal......)

TAYZ

Title: Re: Red motor diff to grey motor diff centre
Post by: colt on March 15, 2006, 11:04:02 AM

Tayz, you've got everything you need. The red uni joint fits straight into your grey tailshaft. Use your u-bolts instead of the old bolt up fitting on the grey uni joint.
Colin

Title: Re: Red motor diff to grey motor diff centre
Post by: fe hotrod on March 16, 2006, 08:22:29 AM

;)wont be minimal for long!!!!he he he...... ;)

Title: Re: Red motor diff to grey motor diff centre
Post by: TAYZ on March 16, 2006, 10:32:40 AM

Diff is now in and working fine, cheers all

TAYZ

Title: Re: Red motor diff to grey motor diff centre
Post by: yogie on March 19, 2006, 01:12:03 PM

Would a HR diff housing fit in a FC wagon, I have powdercoated ready to go...will it fit??

cheer's guys ;D

Title: Re: Red motor diff to grey motor diff centre
Post by: HARKO on March 19, 2006, 03:06:02 PM

Where are you located yogie ?

FE-FC Holden Discussion Forum

Technical Board => Modification Help => Topic started by: TAYZ on March 15, 2006, 10:44:04 AM