??? Does Anyone know of any kits for fitting three individual throttle bodies to any holden six cylinder with a similar look to the triple SU carbies??
russ
i saw an article in the back of i tihnk it was qeensland rodder or queensland custom, somethign like that (cant really remember, started with queensland tho). they didnt look like su's at all, but they were individual throttle bodies that look 100% better than the priginal vk setup
hope i could help
regards
Darcy
Hey Russ, just looking through the index of Choco Munday's book 'Electronic Engine Management' a must if you're going down this route. Maybe try these guys, www.speed-technology.com or www.manifolds.com.au
I'm adapting most of the bits from a VL injection setup to the 202 in my FC. Keen to hear more about your plans.
Thanks for the advice, check out www.efihardware.com it's a bit pricey for me but all very good looking stuff.
PS a friend just got me a "stage 5"? 186 with triple webers so that will have to do until im rich
i know you can get gas carbies that bolt in place.
you may only have to make a thin adaptor plate and use countersunk hex bolts to make it all come together.
if you head down to the jap importers you'll have a ton to choose from from around the 30mmØ up to 70mmØ.
Hi Russ
If you need a programable brain box to run the EFI setup, have a look at this //www.bgsoflex.com/megasquirt.html
Also check out the discussion group: http://autos.groups.yahoo.com/group/megasquirt/
HTH
Cheers
Tony