Print Page - BARE METAL TOOL'S (i used)

Title: BARE METAL TOOL'S (i used)
Post by: COL58FE on October 18, 2005, 05:18:24 AM

G'day,
Â Â Â Â I have had a few question's on what
i used to domy paint prep,well here some
pic's of the tool's i used.The wire wheel can
be bought at the cheap shop's or auto
shop as for the sanding disc any auto
shop too.The rest is up to you and time.
(http://img.photobucket.com/albums/v211/col58fe/tools1.jpg)
(http://img.photobucket.com/albums/v211/col58fe/tools2.jpg)
Cheer's Col. ;)

Title: Re: BARE METAL TOOL'S (i used)
Post by: Glenn 'Stinky' Stankevicius on October 18, 2005, 09:49:09 AM

I don't know how it goes on panels, but you can also get a wire cup brush for angle grinders.
You name it, it will rip it off :o

Title: Re: BARE METAL TOOL'S (i used)
Post by: graham_fuller on October 18, 2005, 10:16:27 PM

Cheers Col,
Good Information very helpful.
Thanks,
Graham

Title: Re: BARE METAL TOOL'S (i used)
Post by: Blown_FC on October 22, 2005, 06:54:11 AM

You can also do what I did and use a FLAP DISC.

Basically a big disc than goes in the angle grinder that has lots of little flaps of garnet rather than one big round sheet.

I don;t have a pic, but mate, these things rip paint and anythign else in it's way off.

You must use them VERY VERY lightly though, otherwise it will chew through your panels, as these discs are also used to grind back welds !

FE-FC Holden Discussion Forum

Technical Board => General Technical => Topic started by: COL58FE on October 18, 2005, 05:18:24 AM