Print Page - 307 into fc

Title: 307 into fc
Post by: minifcvan on July 29, 2005, 04:32:04 AM

hi all i know this will be a stupid question to some of you . ive been talked into putting a 307 in my van.Do i need to use hk engine mounts?? cheers mark ;D ;D

Title: Re: 307 into fc
Post by: julius on July 29, 2005, 05:12:00 AM

If your using a HR converted hadfield crossmember you do, but castlemaine rod shop will supply them if you wish.

Julius

Title: Re: 307 into fc
Post by: JB on August 04, 2005, 08:42:07 AM

I would find a different cross member if it is the front mounted rack if I were you... Done it once, not again!

Jason

Title: Re: 307 into fc
Post by: navy_speed_shop on August 30, 2005, 12:30:41 AM

G'day mate
im starting to plan out my next project, an fc ute with a stock V8. im just wondering what the regulations are for such a conversion. Now i know that ill be using a HR fromt end, with Commodore disc's and a upgraded diff. I was wondering if there are any other areas that i may have to look into for this noble undertaking.
Cheers mate!

Title: Re: 307 into fc
Post by: oldgmh on August 30, 2005, 04:26:57 AM

Depends on your engineer as to what is required, but also allow for collapsible steering column, dual circuit brakes, chassis kit, 2 speed wipers and a demister.

Title: Re: 307 into fc
Post by: 2door350 on August 30, 2005, 09:20:22 AM

check this out seriously sik front end setup, think i'll sell my hadfield setup for one of these....

http://www.v6conversions.com.au/frontend.htm

FE-FC Holden Discussion Forum

Technical Board => Modification Help => Topic started by: minifcvan on July 29, 2005, 04:32:04 AM