Text only | Text with Images

FE-FC Holden Discussion Forum

Technical Board => Modification Help => Topic started by: Glenn 'Stinky' Stankevicius on November 06, 2004, 07:56:31 AM

Title: Rebuilding HR Front End (Part 3)
Post by: Glenn 'Stinky' Stankevicius on November 06, 2004, 07:56:31 AM
Does anyone have the dimensions for the spacer tool 3A11 that is used to install the lower control arms on an HR front end and the 3A12 for the upper control arms?
Or is there another trick I can use?
Title: Re: Rebuilding HR Front End (Part 3)
Post by: mcl1959 on November 07, 2004, 08:33:53 AM
The tool is only needed when fitting NOS lower arms because they have no thread in them.  Set the arm up in place on the bolt and then make a spacer which just fits in the gap between the arm and the crossmember.

Ken
Title: Re: Rebuilding HR Front End (Part 3)
Post by: Glenn 'Stinky' Stankevicius on November 07, 2004, 11:11:10 AM
Cheers and thanks Ken, didn't get to it today anyway, on account of babysitting the tribe.
Text only | Text with Images