:Pwell i need help in cutting the hole's for my header's to go though the inner guard's of my fe,as silly me scrap the fc one they came off before i could copy the hole's .is there a templet or measurement's available from the rod shop.any serious idea's would be great.COL58FE. :-/
check out Glenn's wagon.
FCV8.
he has really neat cut outs for the exhaust. pics in the gallery somewhere.
Cheers
Ed
Col
    I sent you a IM with regards to the holes.
Glenn
glenn i have a question for u,
did u have to have your headers specially made or can u buy them off the shelf so to speak ???
regards david
Get a spud bar & a mattock. Mark (roughly) where you want the holes & start swinging. :D :D
David
    The headers are off the shelf CRS supplied that i also got coated at jet hot coatings in vic who have coated them inside & out & guaranteed them for life not to rust or discolour.
Col
   Its just a matter of trial & error when cutting the holes but you need to allow enough room to be able remove the headers without having to move the engine.
Glenn
G'DAY FELLA'S THANK FOR ALL THE TIP'S,GLEN CHEER'S FOR THAT PM AND I'VE PM YA BACK REGAURDING THIS SUBJECT.COL58FE ;).
COL58FE
Sorry Col I haven't got around to doing a template of the holes as yet but I was looking through some of the photos i have taken during the build & found these for you.
(http://photo.starblvd.net/fcv8/1-4-1/jpg)
(http://photo.starblvd.net/fcv8/1-5-2/jpg)
hope these help
Glenn
COL58FE
Sorry Col I haven't got around to doing a template of the holes as yet but I was looking through some of the photos i have taken during the build & found these for you.
(http://photo.starblvd.net/fcv8/1-4-1.jpg)
(http://photo.starblvd.net/fcv8/1-5-2.jpg)
hope these help
cheers
Glenn
G'DAY GLEN,THANKYOU VERY MUCH FOR THE PIC'S THEY ARE THE PERFECT IMAGE I NEEDED.I HOPE TO MEET ALL YOU NICE PEOPLE ONE DAY.THANK'S AGAIN,COL...