|
Title: Subframe ? Post by: cammo on July 22, 2004, 07:06:32 PM Hello all,
I have 2 rusted inner lower subframes on both sizes. They weren't that noticable, but as I am about to put on a chassis kit I was cleaning the area and my scraper went through one. I had a look on the rare spares site and they didnt have the inners listed anyone know where i can get them (just need the lower part under the seam joint). Also what would be the best method to repair it, I have a boilermaker friend who can assist with the welding, but can I replace them in the car. I thought that cutting up towards the Y joint, seperating the lower halves and using the bolt hole near the floor member as a locating hole would be a good way to do it and keep the measurements correct (after stabilising the vehicle) Waddya reckon? Title: Re: Subframe ? Post by: Ed on July 22, 2004, 10:01:05 PM you can replace it in the car, altho it's a pain.
I did mine out of the car, which has its own fair share of probs. sounds like a good method... go for it! Cheers Ed Title: Re: Subframe ? Post by: mcl1959 on July 23, 2004, 09:37:19 AM I have a s/h subframe with good inner legs. I will cut them off and send them to you for $50 the pair.
Let me know if this is OK or not. Ken Title: Re: Subframe ? Post by: cammo on July 29, 2004, 12:14:45 AM Are the inner legs the same as an EK, cause it is actually an Ek I am doing up.
|