|
Title: cheapest way to get seats resprung? Post by: shane_r on July 08, 2004, 10:57:12 PM The front bench seat on my FC needs to be resprung. What would be the cheapest way to get have this done?
What it be cheaper to just replace the seat with one of the same colour scheme (black and white) or maybe... Get an auto trimmer do repair it?. i am unsure and as the car is intended as a daily driver i don't want to spend to much money on it, although i can't drive to car as is when your bum goes through the seat and you are sitting on the floorpan! Also... How much would each of these alternatives possibly cost me and who would be the best to fix it in Victoria. Cheers Shane... Title: Re: cheapest way to get seats resprung? Post by: RET on July 08, 2004, 11:46:15 PM Shane,
I'm sure some guys from the Vic club can point you in the right direction, but FWIW I had my car's front seat resprung about 12 months ago. It cost $400, which included all frayed stitching and piping repaired, both side panels replaced (the bit that gets torn by the sharp edges under the plastic seat surrounds, for which I supplied material), all springs fixed and new padding. I was very happy with the job done, but obviously that was in Sydney. cheers RET Title: Re: cheapest way to get seats resprung? Post by: Fast_Eddie on July 09, 2004, 12:21:19 AM I recently had a seat resprung and completely recovered for $650, once again in Sydney.
From a safety aspect, let alone the visual improvement to the interior, I consider it money well spent. Considering the cars are more than 40 years old, you may find a seat with better springs than your own, but you would be indeed fortunate to find one that suited your interior scheme. Good luck with it though. I've been proven wrong many times before! Title: Re: cheapest way to get seats resprung? Post by: Glenn 'Stinky' Stankevicius on July 09, 2004, 12:42:57 AM "You get what you pay for"
The cheapest way, would be to do it yourself, if you went to any upholsterer they should have springs to suit. It would probably be a good idea to take one with you. From memory, you'd be able to tip the seat over and work from underneath. A pair of side-cutters to get the old springs out and then all you need is the special fencing pliers (with little cups on each side to hold the clips as you close them) and clips to put new ones back in. If all that doesn't work, you could just get the upholstery springs and add to the existing ones. Title: Re: cheapest way to get seats resprung? Post by: parisian62 on July 14, 2004, 01:05:30 AM Ret and Fast Eddie,
Where in Sydney did you get the seats redone? I'm looking at doing it soon. Ret was that you I passed about three weeks ago travelling south on Woodville Road near the mechano set of lights? Regards Stewart Title: Re: cheapest way to get seats resprung? Post by: earlyholdenfan on July 14, 2004, 05:20:24 AM Shane,
I have a couple of numbers in Melbourne for interior stuff and they are both pretty decent places, for interior re-trim and upholstry etc also advice on seat is: Eastern Auto Upholstry - 5/200 Canterbury Road Bayswater 03 9720-5444 and a seat specialist in St Kilda may be able to advise you further at: 03 9534-4285 Andrew they specialise in seat and custom modifications for all vehicles. Hope this might help a little Matt Title: Re: cheapest way to get seats resprung? Post by: Fast_Eddie on July 14, 2004, 07:39:55 AM Stewart,
Barry Hopkins Motor Trimmers at Hotham Pde, Artarmon are the trimmers I used. My red and black seat was able to be matched quite closely vis colour and texture/grain of the vinyl, however nothing was close to the blue of the ute seat he is doing for me now, so I settled for a slightly different shade. About ten years ago he refurbished a complete interior for me, replacing only half the vinyl in the seats and door trims, and repairing springs etc. He performed an excellent job on that as well. Certainly not the cheapest around, but I can recommend his work with confidence. Regards Edward Title: Re: cheapest way to get seats resprung? Post by: RET on July 14, 2004, 11:55:25 PM The trimmer was Danny Mifsud, of "A Stitch N Time Trim & Upholstery". They're in Croydon Park, phone 02 9798 2702 or 0416 119 224. Tell them you were referred by the FE-FC Holden Car Club of NSW, as he is an advertiser on the back of our club mag.
And no, it wasn't me on Woodville Road. cheers RET Title: Re: cheapest way to get seats resprung? Post by: Spinner on July 16, 2004, 01:31:26 PM And here I am thinking you wanted advice on how to put the seats back into a compromising position... :P ;)
Spinner |