Print Page - Globe won't stay put!

Title: Globe won't stay put!
Post by: Ol_Girl_58 on June 04, 2004, 04:31:12 AM

Hey guys,

Been having a problem with the front left hand blinker on my FC. The globe suddenly doesn't want to stay in the hole, and despite any amount of pushing, doesn't want to stay in.

Problem is, its identical to the right hand globe, but the right hand globe has no problems, and work like its supposed to! I'm confused. Any ideas?

cheers

Josh

Ol Girl 58.

Title: Re: Globe won't stay put!
Post by: RET on June 04, 2004, 04:41:21 AM

Does the RH globe stay in the LH socket? That will tell you whether the problem is the socket or the globe.

FWIW the little lugs (bayonet points) on either side of the globe can break off, causing the globe not to seat properly. Also, they're probably offset on the globe (being twin filament), so it will only go in one way.

Simplest solution is to get an FE ;D

cheers
RET

Title: Re: Globe won't stay put!
Post by: mcl1959 on June 04, 2004, 07:52:25 AM

Sounds maybe like the globe holder is rusted away if the globe is all intact.

This is a common problem as the rubber boot traps moisture in behind the socket and it rusts out

Ken

Title: Re: Globe won't stay put!
Post by: customFC on June 04, 2004, 10:36:58 AM

What Ken says. Get in behind and take a look.

QuoteSimplest solution is to get an FE ;D

cheers
RET

RET....this is a technical board, why would you suggest he takes a backward step in terms of technology. ;D ;D

Regards
Alex

FE-FC Holden Discussion Forum

Technical Board => General Technical => Topic started by: Ol_Girl_58 on June 04, 2004, 04:31:12 AM