Print Page - torana diff

Title: torana diff
Post by: nicko on June 02, 2004, 08:39:33 AM

HI can anyone tell me if an LH Torana diff is longer ,shorter or the same length as an FC diff?

Title: Re: torana diff
Post by: fcvan on June 03, 2004, 12:12:08 PM

Hey Nicko,
I don't know the exact diff length but I do have the wheel track measurements. FC is 1410mm and LH is 1430mm. I don't know what width wheels/ offsets the LH runs but you would think the diff lengths would be fairly close. Hope this helps a little but I'm sure everyone else will add some more exact info.

miikael

Title: Re: torana diff
Post by: mcl1959 on June 04, 2004, 07:48:44 AM

I think the LH diff is the same as FC, if you want a narrower diff then the LC or LJ diff is the one to get as this is about 2 inches shorter

Ken

Title: Re: torana diff
Post by: nicko on June 04, 2004, 11:31:18 AM

thanks ,i will get rid of it and chase up an LJ as i want a couple of inches more clearance on ute for the Western deep dish kidney's

Title: Re: torana diff
Post by: Burnsy on June 11, 2004, 07:50:34 AM

I have just found a LH diff for my car (EK) can anyone tell me what is involved in putting it in, is it a simple bolt up using the torana plates and u bolts or do I need to weld mounts on or something?

Cheers,
Mike

Title: Re: torana diff
Post by: ACE on June 11, 2004, 08:36:34 AM

Hi Burnsy,
You'll have to cut off all the Torana coil spring mounts and weld mounting plates on to accept the EK leaf springs. ;)
Hope this Helps,
Regards ACE 8)

Title: Re: torana diff
Post by: Burnsy on June 11, 2004, 10:31:45 AM

Can anyone give me any advice on setting up the handbrake using the Torana diff and drums.

FE-FC Holden Discussion Forum

Technical Board => Modification Help => Topic started by: nicko on June 02, 2004, 08:39:33 AM