Hello brains trust.
Needing to source some sheet metal to do rust repairs.
Not sure type and gauge that I would need.
I would appreciate any advice, best place in Sydney to source what I need would also help.
Regards
Alex
Quote from: customFC on November 12, 2024, 11:42:14 PM
Hello brains trust.
Needing to source some sheet metal to do rust repairs.
Not sure type and gauge that I would need.
I would appreciate any advice, best place in Sydney to source what I need would also help.
Regards
Alex
Hi Alex,
It depends on what you are trying to repair. For panels I tend to use what I can get for free from cars being scrapped. Roofs are a good get as they have a large surface area and complex curves so you can sometimes cut a section to fit with minimal work.
Cheers
Craig
1.00mm cold rolled mild steel. Rather than buy a whole sheet try a sheet metal shop, for some offcuts.
I bought full sheets of 0.9mm and 1.2mm zinc-anneal.
Sent from my iPad using Tapatalk
yes 1.00mm cold rolled from Buttsworths in Windsor ..my panel man was very happy with it ...
Thanks for the info and suggestions.
Regards
Alex