Tried my workshop manual and the ‘intra-web’ but can’t seem to find this figure anywhere.
Question;
What (if anything?) is specified for the 4 bolts joining the intake and exhaust manifolds together?
Thanks,
Not a torqued setting, just do it up tight.
Ken
Many thanks for clearing that up for me, Ken.
Cheers,
Chris
Tighten them up until they snap, then back them off half a turn ;D
At least, that's what i did when I was a young bloke helping Dad rebuild a motor. Can't say he was overly impressed with me ::).
Cheers,
Harv