|
Title: EJ Vacuum Advance Pipe? Post by: ardiesse on April 20, 2019, 09:59:58 PM Where does the vacuum advance pipe run in EJs? I have a suspicion that it goes from the carburettor rearwards alongside the rocker cover, round the back of the rocker cover, down the back of the pushrod cover, forward at the bottom of the pushrod cover (between distributor and pushrod cover?), and then there's a flexible hose to connect to the vacuum advance.
It's because of the dipstick tube. Any photos would be much appreciated. Rob Title: Re: EJ Vacuum Advance Pipe? Post by: Dr_Terry on April 21, 2019, 05:56:13 PM Hi Rob.
On my EJ the pipe runs the same as my FC, however the connection to the vac diaphragm is with a flexible tube (same as Red motors). AFAIK other than that, they are the same. Dr Terry Title: Re: EJ Vacuum Advance Pipe? Post by: ardiesse on April 21, 2019, 08:40:40 PM Terry,
Thanks for that info. My brother bought a Penola Rose/Fowlers Ivory EJ Hydro wagon from a colleague of my father's for $200 in the early '80s. The splines in the flywheel damper were chewed out, and it was easier to do an engine-out to fix . . . and I remember that one pipe went round the back of the rocker cover. But there may not have been a "standard" arrangement. And I think I've got a vac. adv. pipe that's missing the pipe nut at the distributor end. Rob Title: Re: EJ Vacuum Advance Pipe? Post by: ipg on April 22, 2019, 03:58:13 PM this one goes around the back
https://www.facebook.com/marketplace/item/449891352248031/ Title: Re: EJ Vacuum Advance Pipe? Post by: zulu on April 22, 2019, 04:47:12 PM Rob,
This may not be of help but the hyda-matic on a grey have a small breather can for the tranny on a pipe attached to the box that sits in that area but is not connected to the vacuum (https://i.postimg.cc/fS0hqN9r/FC-219-Motor-Gearbox-install-2.jpg) ($2) Title: Re: EJ Vacuum Advance Pipe? Post by: ardiesse on April 22, 2019, 10:15:31 PM Thanks Gary. I remember the breather pipe as well, but the vac. advance pipe was like @ipg suggests (although I don't have a Facebook account, so I can't see the image).
'Cause I was wondering how, if the vac. adv. pipe goes around the front of the motor, how it sneaks between the upright-EJ ignition coil and the sideplate. By the way, an early distributor will slot into an EJ motor and not foul on the dipstick tube; but I left the advance pipe disconnected. And another item of trivia: an EH generator will fit on an EJ motor, but the pulley centreline is about 1/4" too far forward. Rob |