Has anyone purchased the stainless steel molding clips for a FE?
Rare spare tell me they don’t do a kit and just buy some and see if they fit 😳
But being in Darwin I can’t just duck in to the shop..
Cheers
Once I confirmed which ones I needed, they fitted fine. I think you can order with confidence. http://www.rarespares.net.au/rarespares/SearchPage.aspx?type=partsfinder&model=FE+Holden&car=11e&productgroup=Clips+%26+Fasteners&pno=2
So 2 of each set is what’s required?
Could be too many for an FE.
The location for each mould will have holes in the panels where they came from.
I have an FC special but will look up a parts manual tonight & see if I can find quantity & types.
Hope this helps.
Assuming these are the mouldings you refer to (and if I'm reading the parts lists correctly):
Fender parts 456857 (screws x 12) & SP1407 (Qty 12) = 3 x Rare Spares 4 pc part MS0001.
Door parts 436729 (screws x 2), 7410063 (Qty 2) & 4609429 (Qty 6) = 2 x Rare Spares 8 pc part BMC0005.
For the quarter panel, I find most misc nuts, screws & washers described at a local fastener specialist or on line if RS don't have a suitable replacement listed.
(https://i.imgur.com/wVjhF4v.jpg)
(https://i.imgur.com/BIVljjR.jpg)
(https://i.imgur.com/zeeRACD.jpg)
(https://i.imgur.com/0G4yywk.jpg)
I think that should be 1 x Rare Spares 8 pc part BMC0005
Thanks Dave... I ordered all the clips yesterday so let’s see how I go...
I hope they Arrive quicker than the stuff I got off eBay from them.. 😎
Same slow delivery with Aus Post here, & more goes missing these days.