Fitting remote oil filter and oil gauge ... need a Tee piece or two ... Mr Bitz has chromed for $99 and on Ebay they are up to $550 from Taiwan , WTF !!!!!!! Surely they are available here for only a few $$$ ....any info appreciated ... also , what us the thread type (UNC) ? and diameter ...Cheers , Davo .
Brass tees are about $8 a piece, and easy to source (Pirtek, Enzed etc).
From memory, the engine block hole is 1/4" NPT. The tubing for pressure gauges and remote oil filters is often run in 1/4" inverted flare tubing.
Easiest way is to unscrew the oil pressure sender out of the block, and take it to Pirtek (along with all your other fittings). Line them up on the bench, and the Pirtek guys will sort out the fittings to go from one point to the other.
Cheers,
Harv
Somehow I thought you'd have the answer Harv ... thanks, Off to Pirtek/Enzed ... or perhaps pay $99 to E.B. ????!!!
Went to Pirtek , Port Macquarie and "Dean" sorted it all , no problem ... will be back there for sure ... also sorting hoses and fittings for twin cabs ... highly recommended .
good Davo.. keep that in mind
Quote from: Dave Lakin (Davo Lako) on May 24, 2017, 12:05:45 PM
Went to Pirtek , Port Macquarie and "Dean" sorted it all , no problem ... will be back there for sure ... also sorting hoses and fittings for twin cabs ... highly recommended .
Good news. Pirtek Smithfield (NSW) and Gladstone (QLD) are also pretty damn helpful... have got me out of trouble a few times with grey motor odds and ends.
Cheers,
Harv
Also in Toowoomba and very helpful.
Keith