just picked up a bosch heater for the FE
are the desmister fittings that go under the dash still available
I believe someone on the forum use to do them ???
cheers phil.
Quote from: pbh0069 on June 16, 2016, 08:59:08 AM
just picked up a bosch heater for the FE
are the desmister fittings that go under the dash still available
I believe someone on the forum use to do them ???
cheers phil.
ED was making them but his moulds were pretty sad so he may not be doing them anymore..
Ok thanks
phil
this is what l found when l pulled out the heater , the ends were made up from
freezer iceblock containers
just goes to show that unless you want something original anything can be adapted to suit
these are not seen so maybe see what you can come up with
greg (fcwagoon
(http://i.imgur.com/p9p6aCAl.jpg)
looks like I will have to do something like that . I have no problem making something up IF the original ones are not available.
cheers Phil. :P
Phil, I think original vents are like rocking horse poo but you never know your luck.... Fabricating your own will be quicker and easier I think.
Those flat upholstery nozxles from a vacuum cleaner could work?
i think you may be wright , i was looking at vacuum stuff today.
cheers Phil.
these look allright http://www.ebay.com.au/itm/Kirby-Classic-Omega-Utility-Air-Nozzle-Vaccum-Accessory-/111900675564?hash=item1a0dcccdec:g:iWkAAOSwQYZWujiz :D
I am going to just use some alloy box section with a slot cut into it and a piece of tube on the end and urethane it under the dash vent.
theres some datsun bluebird demister vents on ebay that l think would be close after a bit of
cutting and a little heat to form
only $25 for the pair
greg
Thanks Greg
I was looking at the Datsun ones , but need to get the size of the FE/FC ones to compare.
I am going to see a very good friend on the weekend who has a pair so I can get the size. ;D
cheers Phil.
Preslite heater and vents on ebay