help needed
was going through my collection of stainless trims polishing them up
ready for my fc wagon resto
found that a couple of the trims that run across the top of the front doors
have a slightly different curve at the ends would these be fe door trims not fc ?
thanks greg
Not aware of any difference between FE and FC and the part numbers are the same.
Can you post a photo?
Maybe they have been bent.
Ken
I did not think there was any difference, but the part # is not the same.
12.112 moulding assembly-- front door
Belt ......... FE/225, FE/229 .............LH 7410235
RH 7410236
Belt ......... FC/225, FC/229 .............LH 7411361
RH 7411362
And the lower belt
Belt .......... FE/225, FE/229, FC/225, FC/229 ........... 7410052 by 2
I only added this one to be sure that I wasn't getting the upper and lower mixed up?
I also can't find a record of the part # being changed in the master parts catalogue.
Cheers Stewy 8)
Oops rereading the original post, now I see you meant external chrome stripes. When I read "trim" I thought door trim. My bad :P
Good to see you're on the ball Stewy ;D
Now I have to completely change what I said. Stewy's part number search is right on the money.
FE stripe sits higher on the door so has a very small curve at the front.
FC stripe sits lower so has a large curve at the front.
Sorry about my stuff up :-\
Ken