Below Ive attached a pic of two rubbers that attach into a Smiths heater for the ducting. Mine are in pretty poor condition. Does anyone know of a mod or someone who has made up something to replace these rubbers?
(http://s27.postimg.org/svkt8s46b/Smiths_heater_rubbers.jpg)
Regards Rod.
To the best of my knowledge they are not reproduced and it is not often they are still with the heater
So if it was me I'd clean and lubricate them carefully and wrap them in cotton wool till you need them
Thanks Zulu, I know there are a lot of people out there with the smiths heaters, how do they direct the heat to the windscreen. (something very important in a cold place like Canberra)
There must be a modification out there somewhere?
Regards Rod.
I think this is the correct link
http://forum.fefcholden.club/index.php?topic=24309.0
Some one may be able to do it better
Ed Ho used to make them. He is on this site. Hope this helps
Nick
Thanks Nick, I'm only new and don't know how to look people up. I hope Ed Ho reads this post ;D
Regards Rod
Ed has not been on here for a while, I will send him a message.
Cheers Stewy 8)
Hi guys,
Thanks for the message Stewy!
I made a one off set for beehive to duct adaptors from fibreglass. You just mould the body and vent tubes. Quite a simple job. I can probably post a tutorial on here.
Havent made any vents for some time but will check my molds and supplies... been a bit busy on other projects.
Will look into it.
Just away right now though.
Rod tried to pm you but not sure if it sent. Only have internet via phone.
Cheers Ed
Hey Ed.
If you ever knock up another set of beehive heater adaptors, I'd be interested in a pair.
Regards
Alex