I have this grouse box for sale - no lock, but not hard to find.
Asking $25 plus postage for it. Has FC Holden pictured on the box.
Rare display item in VGC.
Ken(http://tapatalk.imageshack.com/v2/14/11/23/e93aa80f79cab27d063a71ed0d1b07a0.jpg)
Sent from my iPad using Tapatalk
PM sent
Hey stewy , did u buy this mate ,, if not ken let me know , id like it for my collection .. cheers
Hey Slim, that would be Scott (collecta)
Cheers Stewy 8)
My Bad , ::) Long hot day working on FCs in the blistering heat !!!!!!!!
I believe it is sold pending funds arriving.
Ken
Sure is thanks Ken ;D. Does anyone have any idea where inner rubber sleeves for the sta-put could be made or does anyone have one.
I've never tried this but I've had thoughts that a large diameter heat shrink tube might be able to be made work.
1. Make a wooden buck turned to shape of the tube, cover with grease proof paper.
2. Shrink tube down gently leaving excess at the front.
3. Get something like an ice cream container and cut a strip to wrap around the front.
4. Warm the heat shrink and fold it back over the plastic. Tricky........
5. Trim to suit.
Best I can come up with
Ken
I used bicycle inner tube for the "pipe" bit of mine, and folded the ends over. This bit worked really well. I used the same rubber for the "clamp" bit that the lock goes through - harder to do, lots of cut, stretch, clamp and glue.
Cheers,
Harv
you could try the foam rubber insulation tubing that goes over air con. pipes, that woid give it a snug fit.
Jim
where would won get a key cut for one of these as the fe i picked up today has one key and i would like a spare
regards fatboy
Thanks for the ideas ;).
Ian, I just use my local locksmith and pick a key blank that matches or looks similar, very easy for them as most are Lockwood padlocks.
cheers
Scott
I was at a locksmith yesterday and they couldnt do it .They made two keys for the ignition and tailgate handle and charge $17 for two keys .I nearly d
fell over
regards fatboy