Print Page - HR front end with HT discs

Title: HR front end with HT discs
Post by: DN2168 on May 11, 2014, 08:29:32 PM

I am about to start rebuilding a HR front end for the Ratty Taxi, I have a set of HG,K,T stub axles and steering arms. I know they bolt on and lower car by about an inch. What problems could I encounter with this setup eg, alignment issues ect ? Any help appreciated

Title: Re: HR front end with HT discs
Post by: mcl1959 on May 11, 2014, 09:04:58 PM

The conversion is OK but use the HR steering arms instead.

Ken

Title: Re: HR front end with HT discs
Post by: hsv-001 on May 12, 2014, 11:24:19 AM

That's right the steering arms curl inward more because the HK,T,G track is wider allowing the inside wheel to turn sharper than the outer so fitting on a HR front end can cause exess scrubbing when turning .Haydn

Title: Re: HR front end with HT discs
Post by: DN2168 on May 13, 2014, 07:04:50 PM

Thanks for the help Ken & haydn.

FE-FC Holden Discussion Forum

Technical Board => Modification Help => Topic started by: DN2168 on May 11, 2014, 08:29:32 PM