|
Title: FE shell Post by: FC Dave on September 14, 2013, 05:28:51 PM Stripped down a VERY rusty FE sedan today. Still on this shell is a good roof & b pillars with no seat belt holes. The rear quarters around the tail lights are ok too, until you get to the lower sections. Located Robertson NSW. Just checking if any one wants bits like this. The rest is ready for a trip to China to make some Great Wall utes. Dave
Title: Re: FE shell Post by: mcl1959 on September 14, 2013, 05:42:57 PM Dave, can you post the details of the ID plate and chassis number please.
Would appreciate it. Thanks. Ken Title: Re: FE shell Post by: FC Dave on September 15, 2013, 01:21:23 PM Hey Ken ID is 225 13798 S
Trim 355/465 AO Paint 253/7773 Should be an FE special, Sydney Build. Single tone Ascot Grey Fall Red & Parchment Ivory interior. I couldn't find the number on the inner guard. Are the FE ones in the same place as the FC? This Id plate is available if anyone is interested. Title: Re: FE shell Post by: mcl1959 on September 15, 2013, 02:05:04 PM the chassis number could be on the skirt near the battery if it is not on the drivers side.
thanks ken Title: Re: FE shell Post by: FC Dave on November 05, 2013, 05:19:07 AM Ken, I have had a scratch everywhere, and no number on the sub.
Still available off this FE are some stainless trim, roof, rear seat, windscreen,ID plate, glove box lid & dash that was Chrome,Door strikers, cowl vent.. I have a couple of very rough sub frames if some one is looking for a K leg. Title: Re: FE shell Post by: hawk on November 06, 2013, 08:46:59 PM Hi Dave, do you have the boot springs available on the shell.
Regards,Greg. Title: Re: FE shell Post by: FC Dave on November 06, 2013, 09:54:38 PM No I don't, sorry.
Title: Re: FE shell Post by: FireKraka on November 07, 2013, 12:05:00 PM Greg
I picked up a box of parts a while ago and have a number of boot springs PM me if you are interested I am in WA but it would not be hard to send something as small as them. Regards Neil H |