Print Page - Roll over jig centre point / Balance point FC Ute

Title: Roll over jig centre point / Balance point FC Ute
Post by: MAF on February 07, 2013, 03:10:23 PM

Hi Guy's

Do any of you know the ideal centre point for a roll over jig to get the best balance? Looking for a measurement from the floor up to the centre point??
The jig is for an FC ute.

Cheers
Mike

Title: Re: Roll over jig centre point / Balance point FC Ute
Post by: JB on February 07, 2013, 05:16:20 PM

I found the centre of gravity to be at the ute tray floor level... So would say on a sedan where the boot meets the beaver panel.

Best guess.

Cheers
JB

Title: Re: Roll over jig centre point / Balance point FC Ute
Post by: MAF on February 07, 2013, 10:08:04 PM

Thanks

Title: Re: Roll over jig centre point / Balance point FC Ute
Post by: MAF on April 30, 2013, 11:52:26 PM

The balance point suggested worked great and the car is now on the rotisserie ready for the next steps

Title: Re: Roll over jig centre point / Balance point FC Ute
Post by: JB on May 01, 2013, 05:07:28 AM

Title: Re: Roll over jig centre point / Balance point FC Ute
Post by: fe350chev on May 17, 2013, 01:15:38 AM

good luck.

FE-FC Holden Discussion Forum

Technical Board => Restoration Help => Topic started by: MAF on February 07, 2013, 03:10:23 PM