Having a red motor in my FC and a HR cross member will EH and HR sumps both fit.
Thanks
Red_Devil
Red, EH sump is the one to use. The low part sits behind the drag link.
I have recently been told that the HK,T,G sump will fit. I haven't seen one installed though. Any one else heard this? They are very similar to the HR sump.
Colin.
had a reply from John Rap indicating EH sump and pick up.
Thanks
Red_Devil
EH after many hours of research.
Keep an eye out for them. They are not cheap these days.
Thanks, yes everything has dried up, everything is now a collectors item and priced accordingly.
EH is the one to use
Butt you can use HK-T-G and LC-J
BUTT the motor WILL sit about 1" forward to cear
[ well that is in FB EK ]
These are pages out of a Repco exchange engine catalogue
(http://s8.postimage.org/62mz4gj0h/img001.jpg) (http://postimage.org/image/62mz4gj0h/)
(http://s13.postimage.org/m7477tb77/img002.jpg) (http://postimage.org/image/m7477tb77/)
(http://s18.postimage.org/3nilvl32t/img003.jpg) (http://postimage.org/image/3nilvl32t/)
(http://s7.postimage.org/ygikxdodz/img004.jpg) (http://postimage.org/image/ygikxdodz/)
Thought they might give an insight to what they look like.
Cheers Stewy 8)
Thanks heaps for that info, Stewy! Definitely worth a 'bookmark'
I would have thought being an HR front end the ideal would have been HR?
Pinky.
Stewy how good was that down load 10/10
That is what makes this site great.
Regards
John
Red_ Devil
Slims wrecking an EH ?
Pinky,
Because the red motor has to move (back i think) from its original mounts on the HR Front end.
a HR sump then hits.
Cheers
John
See how the KTG sump has the stepped back? Apparently this allows it to fit. To my mind if they fit in FB-EK, they should fit in FE-FC.
Colin.
An fyi anyone running a rear rack torana sump fits easyy ;)