Hi all,
Is it possible to fix a wiper cable where the small ring on the wiper motor end freely slides up and down the cable?
Cheers,
Graham
Has no one had this problem before?
Cheers,
Graham
I may be a bit slow but im confused
Can you post a pic of the problem part?
If its the bit that I am thinking of...you must have broken the end off the cable.
Cut the outer case back, slip the ring over the inner cable, heat the cable and tap it flat.
Regards
Weddo
Graham - it has taken me this long to work out what your problem is / was :P
THe small metal ring is supposed to move up and down the cable, just not come off the end.
The metal disc pulls the switch in one directio but the end of the wire pushes the switch the other way.
So your cable is not broken ;D
Ken
Thanks.But how does that work with the nasco 2 speed electric version?
Cheers,
Graham
Hi Graham,
if you look here at the unit in Accessory of the Week
http://fefcholden.org.au/forum/index.php/topic,7278.0.html
the fitting instructions show that the ring on the end of the cable is captive once the cable outer is clamped
So I would think as long as the ring can't fall off the end of the cable, all should be well
Gary
PS If you need to see one mounted, I can arrange to meet or send pics
Thanks Gary,
I will have another look. Maybe the distance the outer comes out from the clamp is critical as they do say 3/8". Could you take a picture of the switch stem that holds the ring, maybe mine is not all there?
Cheers,
Graham