Hi all
Just wanting to know if i can put a petronix 40000 volt flame thrower coil on my 138 grey motor
Will it burn out points etc?
Cheers Darren.
yes you can, you are going to get there points replacement module
can't recommend it highly enough
if you dont want that coil you can just get a Bosch GT40
Thanks John
I just have the coil and not the other bits to replace the points
is it still ok to use the coil.
cheers Darren
Check the coil is for 12 volt operation and not for 7 volt - grey motors use a 12 volt coil and reds use a 7 volt coil. So the coil you have must be to suit a grey motor, not a red motor.
Ken
Thanks Ken,Will check
Cheers Darren
in the pertronix range i think its the 3 ohm coil you need,
but if it for a 6 cylinder i think they only sell 3 ohm
http://www.pertronix.com/prod/ig/flame/coils/chart.aspx
Thanks again John
Yes it is 3ohm
I was a bit worried it would be to powerful for my grey motor system.
Cheers Darren
its a very common upgrade ;D
Hey John
Do you know any thing about wheel offsets for fc vans.
Looking at buying a set of 13x7 with 70mm back space and 0 offset.
Will they fit?
cheers Darren
nothing sorry mate
ken might know, as there connected to the brakes and his the guru on them