How do I remove the lower conrol arm shafts. The ones that go through the HR front end. Book says use tool #???, is there another way?
regards fred
I assume you want to replace the shaft??? The easiest way is to grind 2 flats onto the shaft and undo with a shifter. If you want to take out the shaft and use it again then you will need to make a tool from an old bush. It will need a cap welded onto it so that you can tighten up the bush onto the shaft and then unscrew the shaft.
Ken
Thanks ken am replacing the shaft, is there anything else I should know ???? about replacing
regards fred
Tighten it up as tight as you can ;D
Ken