Hi all,
I am away at work for a couple of weeks and I am redoing my king pins (after hours of course) in the workshop. I have fitted and reamed out the bushes but I left my manual at home and Im not sure how to assemble the whole lot. I was hoping someone might have a picture or diagram they could post to help me out.
Rob
Email sent hope it helps.
Regards
Wayne
Your email did not seem to work.
Regards
Wayne
Wayne,
If my email didn't work could you post it on here.
Thanks.
Rob
(http://[img]http://i878.photobucket.com/albums/ab350/wayne9606/Car%20Stuff/section3kingpins_Page_1.jpg)[/img]
(http://[img]http://i878.photobucket.com/albums/ab350/wayne9606/Car%20Stuff/section3kingpins_Page_2.jpg)[/img]
Regards
Wayne
Oops too many (http://s
(http://i878.photobucket.com/albums/ab350/wayne9606/Car%20Stuff/section3kingpins_Page_2.jpg)
Regards
(http://i878.photobucket.com/albums/ab350/wayne9606/Car%20Stuff/section3kingpins_Page_1.jpg)
Thanks Wayne your help is much appreciated.
Rob
I have another question. Is there a difference between left and right stub axle assemblies, are they interchangeable between sides?
Rob
Yes left and right are different - don't mix them up
Ken
Thanks Ken.
Rob