Print Page - NSW trailer rego.

Title: NSW trailer rego.
Post by: Ed on April 30, 2009, 12:03:10 PM

Hello,

Can anybody help me find some info on how to register a new "homebuilt" trailer in NSW?

do u need a manufacturing plate / license, inspection etc?

Planning to build a bike trailer.

Cheers

Ed

Title: Re: NSW trailer rego.
Post by: REDMR2RED on April 30, 2009, 01:58:44 PM

Not sure about NSW but here in VIC if the trailer is less than 3M (10 feet) and no wider than the vehicle then no registration is required.

Check this out, the National Code of Practice for building small Trailers

http://www.infrastructure.gov.au/roads/vehicle_regulation/bulletin/pdf/vsb_01.pdf

Cheers, Red

Title: Re: NSW trailer rego.
Post by: Ed on April 30, 2009, 02:06:56 PM

Hey Red,

Just found a manufacturer's compliance plate which you can buy.

just need to fill it in. Unfortunately NSW is not so generous with no rego requirements.

rego of a bike trailer will be about $52 pa.

cost increases with size / weight.

Looks like, all I need to do is stamp in a VIN #, just researching all this before I go ahead.

Cheers

Ed

Title: Re: NSW trailer rego.
Post by: Hewart on April 30, 2009, 05:08:55 PM

Hey Ed.....

Talk to Leon Spicer. He built his own car trailer for the last nats and might be able to point you in the right direction.....

Cheers, Les...

Title: Re: NSW trailer rego.
Post by: Ed on April 30, 2009, 05:15:22 PM

Good idea Les,

I'd forgotten about that.

I think the smaller trailers are easier to rego, but certainly Leon would be a good starting point.

Next meeting

Cheers

Ed

Title: Re: NSW trailer rego.
Post by: FCGos on April 30, 2009, 06:47:09 PM

Ed
You will need a trailer compliance plate which can be purchased from most trailer parts suppliers. You will then need to fill the blank details in which is generally done by engraving. Try the address below which will start you off with the necessary info, whilst in the RTA site there are other useful downloads such as braking, lighting, coupling and safety chain requirements. You will also need to have the trailer inspected at a Blue slip AUVIS checking station (one that can do unregistered vehicles) then with alldocs complete it is simply off to the RTA and hand over your cash.

http://www.rta.nsw.gov.au/registration/downloads/vsi/vsi52.pdf

Hope this helps Wayne

Title: Re: NSW trailer rego.
Post by: Ed on May 01, 2009, 08:25:20 AM

Hi Wayne,

Yes that does help alot.

I trolled the RTA website but couldn't find all that info!

another visit to the blue slip station, where they will nit pick.. lol :-\

I find the compliance plate quite funny, particularly as you just stamp it and attach it yourself. I found a supplier who has these.

Cheers
Ed

FE-FC Holden Discussion Forum

Technical Board => General Technical => Topic started by: Ed on April 30, 2009, 12:03:10 PM