Text only | Text with Images

FE-FC Holden Discussion Forum

Technical Board => General Technical => Topic started by: FATBOY on August 17, 2008, 03:28:19 PM

Title: FITTING OF FUEL TANK
Post by: FATBOY on August 17, 2008, 03:28:19 PM
What type of caulking do you use between the tank and the floor
regards fatboy
Title: Re: FITTING OF FUEL TANK
Post by: JB on August 17, 2008, 04:14:00 PM
Hey Fatboy,

I used sikaflex... That sorted it. Until I put a hole in it. Real bitch to get out, but would use again.

Cheers
Jason.

Title: Re: FITTING OF FUEL TANK
Post by: FATBOY on August 17, 2008, 04:37:18 PM
Kool i use sikaflex all the time will go under the house and get some and put the tank in the ek ute now
regards fat
Title: Re: FITTING OF FUEL TANK
Post by: FC427 on August 17, 2008, 05:16:25 PM
Fatboy Butyl Mastic ......FC427.........
Title: Re: FITTING OF FUEL TANK
Post by: FX1975 on August 17, 2008, 05:23:01 PM
I also use a mastic type sealer as is agood seal and easier to remove tank if necessary than sikaflex
                                             cheers
                                               Frank
Title: Re: FITTING OF FUEL TANK
Post by: weddo on August 17, 2008, 06:40:56 PM
Definitely Butal Mastic(warm it up in a bucket of hot water before you use it) it will seal but not harden, where as Sikaflex will cure and become like an adhesive. 

regards
Weddo
Text only | Text with Images