G'Day all
I removed a Smiths door type heater from an FC ute that had the engine removed.It is complete with demister ducts and hoses.
Where do I connect the hoses and do the demisters get screwed through the dash vents as they were on the ute. ???
Gary
Gary,
The answer to your second question is yes.
I've had a look through my limited collection of grey motored engine bays, but don't have any shots that clearly show heater lines. Sorry.
cheers
RET
Hi Gary
With the water pipes, one gets plumbed into the side of the water pump . The other goes to a tap fitted to the side of the lower thermostat housing. Sorry, have no pix either.
The demisters get screwed to the dash vents as per the ute. I've got a diagram of this if you need, also a template for fitting the heater.
Cheers
Tony
Hi Tony
If you could email me a copy of both that would be great.
Also got a mint Nasco Autoheat heater from the same farm hanging up in a shed.Dunno if you can shed any light on this it has a number M32051 or M32057 on the back and is similar to the Smiths.
Thanks
Gary
Hi Gary
I've sent those diagrams, hope they help.
Cheers
Tony
Thanks for the diagrams Tony
Cheers
Gary
Hi Tony,
could I have a copy of those diagrams as well? thanks
Tony
tmudie@bigpond.net.au
g'day guys
just acquired a smiths heater.if anybody has a copy of components & or fitting instructions or anything else relevant i would be most grateful if i could have a copy.
its missing control panel & tap but i'm prepared to make something to get by
thanks trev