FE Panel van for sale on ebay.
http://cgi.ebay.com.au/FE-PANEL-VAN_W0QQitemZ250085778971QQihZ015QQcategoryZ1258QQrdZ1QQcmdZViewItem.
Mike
I went and looked at this car. It needs a whole new floor from bottom of firewall through to rear bumpers. Also new sills. Bottom tailgate needs replacing as well as wheel door. Rust in front subframe and front corners of bonnet in the usual places but not to bad. Both doors , front guards and L H S lower quarter are damaged . Lots of minor surface rust inside and out .Motor turns freely by hand . The car is mostly complete and unmolested as stated in the add.
Brad.
QuoteI went and looked at this car. It needs a whole new floor from bottom of firewall through to rear bumpers
Don't you mean new floor pan sections?
No mate I mean It needs a WHOLE new floor from front to back . Unfortuneatly the one that,s in it is GORN :o.
You may as well throw a washer on the ground and start welding floor sections onto it. The floor is shagged mate. The best way would be to weld a whole new donor floor into the car . 60 / 70 % of floor is stuffed it's like a sieve. Inner sills seem ok though
Brad
Flintstones comes to mind lol
I have an FC Vanette that is just like that, the floors are gone but the chassis is good. Water gets in and rusts its way out. I do call it my Fred Flintstone car.