Print Page - Wot tailshaft fitz?

Title: Wot tailshaft fitz?
Post by: FCwagon on September 19, 2002, 07:41:28 PM

Hi all,
can someone tell me if there is a stock tailshaft that will fit an FC with a 179 red and Trimatic.
thanks,
Leigh

Title: Re: Wot tailshaft fitz?
Post by: Liam Moloney on September 20, 2002, 09:42:12 AM

Hi Leigh
I had the same problem.
Originally i had a HR tailshaft i think but i used a UC torana manual shaft, It was a bit shorter than usuall.
It was a good length but you wouldnt want to go much shorter.
hope this helps Liam

Title: Re: Wot tailshaft fitz?
Post by: brads59 on September 22, 2002, 10:32:08 AM

Hi Leigh,I have a brand new tailshaft with new unis and just balanced that will suit your needs im looking for $80
for it.Im in Adelaide but ive shipped parts all over so its not a problem.Just pm me if interested thanx BRAD

Title: Re: Wot tailshaft fitz?
Post by: Damon on September 25, 2002, 09:59:11 AM

Hi again Leigh,
I have just done all the required measurements for my project and found that an EK automatic tailshaft with a HG trimatic yolk fits nicely.
I am running a RH diff though, I guess that you would be too.

I can give you the length later on in the week if you need?

Hope this helps.
Damon.

FE-FC Holden Discussion Forum

Technical Board => Modification Help => Topic started by: FCwagon on September 19, 2002, 07:41:28 PM