Wanted bare front cross member any condition. Need it for the mounting plates only as i am doing a conversion. I am located in melbourne so local would be good
Regards Brett
would an fb one do?
there are no engine mounts on the cross, there is one on the outrigger, is that the one you want
Thanks guys for your replies. As for the FB cross member i am not sure if the mounting brackets are either the same or same positions as the FC FE. Can anyone verify this. The crossmember i am after is the main one where engine mounts normally go on red motor vehicles. In other words the member that holds the upper and lower wish bones.Regards Brett
Brett, if it is just the mounting plates you need then a FB one will be fine as the mounts are the same as FC. In fact the mounts are the same from FE right up to HR. However the crossmember is a different shape from FB onwards so would be no good if you want to use part of the crossmember for your setup.
Ken
Thanks ken your full of knowledge.Therefore i am now looking for a bare cross member from FB to HR as i only want the mounting plates.These are being transfered to a torana front end as my original front end had been reconditioned and it would be ashame to cut this one up.
Regards brett
By the way Ken i haven't forgot about the trims its been because i have been interstate.Will call you soon.
In that case I have an fb one if you want, and Im in melbourne! Call me on 0414 557 622 thanks Trev.
Thanks guys for your help. i have recieved a donor cross member from trev. i have also had my commodore rear end with trailing arms fitted to my fc and looks fantastic. any questions i would be more than happy to answer. Trev has also sighted this conversion.