Print Page - wheel alignment specs

Title: wheel alignment specs
Post by: fjmate on September 28, 2006, 10:24:04 AM

Hi people - this is'nt about FE or FC holdens but i have come here out of frustration with a mates FJ holden
He has just recently restored it and brought to me for an alignment and i found the camber to be +3 degrees!
way out he tells me that nothing has been changed but the upper control arms look like theve been replaced
Is there differant control arms for these that might have been fitted ? :-/

Title: Re: wheel alignment specs
Post by: fjmate on October 08, 2006, 07:26:27 AM

Sorry to be a pest but does'nt anybody know of somebody that can help! :(

Title: Re: wheel alignment specs
Post by: blacky on October 08, 2006, 12:47:23 PM

Try sending a PM to Dr Terry - he has a workshop in Sydney and may be able to help .

Title: Re: wheel alignment specs
Post by: mcl1959 on October 09, 2006, 01:33:30 AM

fjmate, what is the range of readings you get when you adjust the camber setting. Is 3 degrees positive the smallest angle you can get from the adjustment. Maybe possible that the stub axle is bent.

Ken

Title: Re: wheel alignment specs
Post by: fjmate on October 10, 2006, 09:21:50 AM

Hi guys , thanks for the replys , the lowest camber i can get is +3 when i adust it it goes nearly to +4 degress - its the same on both sides thats why i was asking if there were differant upper control arms available that might have been incorrectly fitted
thanks

FE-FC Holden Discussion Forum

Technical Board => General Technical => Topic started by: fjmate on September 28, 2006, 10:24:04 AM