|
Title: WTD: door striker plate spacers. Post by: Ed on May 18, 2006, 09:16:06 PM Hello,
I am after, 2 "thin" door striker spacer plates. there are two thicknesses cant tell you off hand what the thin plate is 2mm perhaps? side by side the differnce is noticeable. very cheap or preferably for free. any help appreciated. Cheers Ed Title: Re: WTD: door striker plate spacers. Post by: nitrox on May 19, 2006, 03:52:08 AM Hey Ed,
if they are the same as EJ/H you can have 2 free from me I'll check the thickness tomorrow and get back to you. Cheers, Lindsay. nitrox(at)samford(dot)net or 0412 884 060 Title: Re: WTD: door striker plate spacers. Post by: mcl1959 on May 19, 2006, 07:16:18 AM Ed I have some of the thin ones available, can you check the thickness of the ones you have & I will confirm that the ones I have are thinner. I think EH striker plates are different shape to FE ones.
Ken Title: Re: WTD: door striker plate spacers. Post by: Ed on May 19, 2006, 08:44:18 PM Hi Ken,
Shall measure up my plates on the weekend. Thanks for pointing out the thicknesses of plates at the Nats too, it's the little things like this that often go un-noticed. Nitrox, thanks for the offer much appreciated, unfort. the EH are probably the wrong shape. Cheers Ed Title: Re: WTD: door striker plate spacers. Post by: nitrox on May 20, 2006, 03:36:34 AM No worries Ed, I wasn't sure if they would be simialr (FC and EH) cheers, Lindsay. ;)
Title: Re: WTD: door striker plate spacers. Post by: Ed on May 23, 2006, 03:30:21 AM Hi Ken,
.. and for anybody interested in door plate striker thicknesses. the thickness of the "thick plates" was about 5/64" (sorry about inch measurements, i only had a inch rule at the time). the thin ones are about 1/16" I believe. Cheers Ed |