Graeme

                will have a look tomorrow  should have one

            greg  ( fcwagoon )

  Just seen an advert  on Facebook    Taylors automotive is closing down .

  Were comments a couple of months ago about supply and contact  ,  looks they are selling all panels and dies off now

 classic carbs in queensland

  Mine still has the black cardboard type in it, but some parts have dropped .so looks like l will be replacing the lot
   the worry is will these sound deadeners stick and stay there
 
   you can imagine the amount of heat that hits  the roof directly on top so hopefully someone
    has used something that works

       fcwagoon

  John
          there is a nut bolt  on the ratchet arm that you can disconnect ,its there to adjust the downward  tension on the
         air vent cover   this will give enough height on the vent  to get the seal to remove and reseal

         fcwagoon

 What sort of insulation are you looking at for the inside roof ,
     
    fcwagoon

 happy to help out with parts   arthur.
                 nice to see parts being reused into projects keep up the good work mate

  no worries mate

     l have this one if it suits

  email pic sent

   give us a yell if you ned anything

    fcwagoon     

   on eBay

 Try eBay there are cd versions of the parts manual on there

  When l had both old and new rubbers side by side the base was larger on the new rubber
  which made the rubber sit higher .only because there was to much rubber to go in channel 
   different texture on the new one a lot softer ,more like sponge than rubber

      greg    (fcwagoon)

 there is one,it is  either beta auto or thompsons that has a larger base on it  which makes it harder to fit and also
 sits to high ,   l fitted one of these to a club members car only to find it didn't fit well

   l ended up cleaning up the original ,or it might have been an old rare spares one and before fitting found that the square base
       that fits it the channel was slightly smaller

        made fitting easy and boot lid sat nice .  hope this helps

   chassis for what ?

 glenn did you get my email

   thanks greg   fcwagoon

 

   glenn   email sent

 Glenn
          how much of the off white would be needed for a panel van
          have a mate doing an original pmg postal van
          so thinking its the same as ute maybe ,you might have a better idea on the vans on the amount
          also he is checking the color of his original color he thinks its white

         
                   thanks greg      (fcwagoon)

 lm  the same , happy to help if l can with spare parts and advise people are  after  ,but my own project has been sitting on the        rotisserie  at the back of the shed now for 18 months . other projects sometime take priority over the wagon but l will get there one day   ,  l still check in  at least three times a day and enjoy looking at builds .
 l have plenty of pics but getting them up is frustrating sometimes especially  for us oldies

   keep up the good work moderators   , great site

    fcwagoon