Hi Dave,

Thanks for the information, it is very much appreciated.
Cheers
John

I checked John's rubbers against my FB/EK wagon, and sadly they are too far different to be used (can't be cut-and-shut as the dimensions are different).

However, I also checked the rubbers against my FB/EK ute, and they are a beautiful fit. A very small amount of tirmming is needed, but otherwise perfect.

Cheers,
Harv

Thanks for the information Harv, much appreciated.
Cheers
John

George Schembri, Graham Fuller & myself are meeting at Pheasants Nest @ 10.30 for a 11.00 for a departure. ON THURSDAY
Cheers
John

George Schembri, Graham Fuller & myself are meeting at Pheasants Nest @ 10.30 for a 11.00 for a departure.
Cheers
John

Thanks Rob for your kind offer, I hope I don't need your services.

Cheers
John

Please excuse my ignorance, what is it?

Cheers
John

Does anyone have an ignition wiring diagram for an FC sedan. My wife’s FC was running a little rough on longer runs so I gave the plugs and points a clean. Afterwards the engine cranks but won’t fire. Pulled a plug, no spark, tried direct for the coil, no spark.Replaced the coil but still no spark. I think I may have disturbed some of the wiring while I had the dizzy cap off?

Thanks,
Wayne


Sent from my iPhone using Tapatalk

Have you got power to the coil from the ignition switch??

Can anyone put me onto a set left and right front seat corner plastic trims black. FC holden. Please phone 02 64521619 or betterlonghurst@gmail.com
Thanks Peter

Hi Peter, I have sent you an email. Cheers John

I will be taking a few sets to the Nationals in Canberra.
Cheers
John

And they are a good product. See more discussion here: Rear body to bumper seal available

Thanks Dave.

I will be taking some sets to the Nationals in Canberra.

I have the rubbers that mount on the body & under the bumper, maybe some one can link the photos.
Thanks John

Thanks
Haydn the rear main is in now,  it's the endcap bearing  gasket that I will trim and butt the sump gasket up to the endcap.
That way it is continuous with the surface of the block.
Getting there!!

Getting close now Nick.
John

The plastic FC style trims are available from Rare Spares but they are expensive. The metal seat trims can be fitted but they finish a little lower up the seat back. If you decide to use metal seat trims it's a good idea to give your upholsterer a set before the seat covers are made. If you go this way I have a pair of metal sides complete with good SS moulds. I'm after a pair of FC moulds .......

I have a set of used Fibreglass Seat Trim Moulds, I would like to sell $50.00 plus freight.
Cheers
John

I am after a pair of Glove Box Hinges if anyone has a wrecked car or spares.
Cheers
John

Congratulations Jim, Pleased you have joined the club,enjoy retirement.
Cheers
John

Have you filled the diff with oil before spinning the wheels?
Cheers
John

I have a late 59 sedan & it is mounted between 3 & 4.
Cheers
John

Hi Ken,
Maybe someone can take the Nationals for me.
John

Hi Ken,

Is that brake line for sale?

Cheers,
John